Valarra on C6 Corvette
Clean Title, Manual Transmission, 46K miles
Stock Motor, Short throw shifter
Located in Oldsmar Florida
$100,000
Firm on price
Please read entire post and if you have questions call/text me
Chris 727-458-1449
This build took me 15 months and was done with a lot of attention to detail.
I took my time on the bodywork, using block sanding on the primer, basecoat and clearcoat.
Wheels
-Amani Forged--22x12 Front, 24x14.5 Rear
-Vredestien 295/30/22 Front, 355/25/24 Rear
-less than 100 miles on rims/tires
Suspension
-Custom AirTekk Air Bag Struts with built in Dampers
-Air Lift Performance 3P Air Management
-VIAIR 444C Compressor
-28" FLO Airride Billet Tank
-All Boeray Air Fittings (zero air leaks)
-12V Purge Solenoid to drain tank
-Upgraded One Way Flow Valve
-Camber/Tow/Alignment performed at set ride height (100psi)
Electronics:
-DS18 8" PRO-CF8.2NR Mids
-DS18 3" PRO-TWN4 Tweeters
-Skar SVR-12 Subwoofers
-Skar RP-1500.1D Mono Amp powering subs
-Skar RP-150.4AB Amp powering mids/highs
-Skar 12V AGM 300 Amp 20Ah additional battery
-PVR Digital signal processor used for crossover, gain and amp sequencing
-DS18 0GA CCA wire for main power/ground feed
-Android 10” Head Unit
-360 Cameras
-ANCEL Bluetooth Battery Monitor
-Wolfbox 12” 4K Mirror Dash/Backup Camera
-High/Low Beam 5” fog lights
-LED headlights
-Flowing LED Running/Turn Signal Lights
-12pc white LED rock lights
-4pc RGB underglow lights
-6pc RGB interior lights
-White LEDs mounted under mirrors
-Fused power distribution block with correctly sized fuses
-Relay Box 6 Slot for LEDs and purge valve
Steering Wheel:
-Custom Made Forged Orange
-Black Alcantara with orange stitching
-LED Display OBD2 information
-Air bag cover with Valarra logo embroidery
Brakes:
-Custom made (probably largest BBK on C6 ever)
-Front: 410x36mm Drilled/Slotted Rotors
-Rear: 405x32mm Drilled/Slotted Rotors
-6 Piston Calipers with color matched powder coat
-Upgraded Brake Lines
Paint:
-Tempco Pearl Hugger Orange Basecoat
-Limpco Black Basecoat
-Evercoat SlickSand Polyester Primer
-Lumabase Euro Clear
-Entire body block sanded
-Clear coat block wet sanded and buffed
-Rear Brackets Powder coated Gloss Black
Mics:
-Braum Racing Seats on factory electric rails
-Titanium Burnt Blue Body Hardware
-2mm Sound Deadening mat in trunk
-Tons of custom 3d printed parts
-All connections made using Deutches Connectors
-Labeled heat shrink connections
-Micro Relay board in footwell to activate left mirror camera with factory turn stalk
-Audio system tuned with oscilloscope to set gains and DSP for all crossover points
Build Videos
Components
Body Work
Subwoofer Box Fab
Valarra Finished